P0897 OBD Engine Code Logo   Code #P0897 -
Transmission Fluid Deteriorated

Select a Code:


changed fluid and filters light still on checking here

check trans light on can not reset???

Mack MR688
P0897 CODE ACTIVE


0808 airbag peugot

Peugeot
Code 0808


0057

go fuck yourself

just plugged in scanner and code Po897 popped up. just wanted to know what would cause the issue besides bad fuild

poor shifting good tranny flush should solve it

the code p0897 is on shift pqad will is set trann. light off?

code p0897

none, because the truck only got 13433 miles

International 4300
truck 13344 miles, oil is clean , tried to clear it, keeps coming back


Trams light always on, tried to clear it, keep coming back

do not shift light

Just show code p0897

P

did not do anything, just checked code

TRANSMISSION LIGTH FLASHING ON DASHBOARD

CODE P0897

Mack
p0897 code came up. replaced the oil and filter. code still active and will not reset


Cadillac SRX
obd code P0897 what do this mean


d1p0974

transmission not shifting

0897 AND 0843



Report your Experience!

Tell us about Code #P0897

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0775 need help in locating b valve solenoid or do i need the tcm that goes with that tranny

P0775 Nissan Maxima
i just put in a used tranny it does not go forward or reverse got engine code p0775 no b solenoid presure my trip tronic gear stuck on five please help


P0863 Ford F-250 Super Duty
engines check light code PO863


P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again



Other Check Engine Light Codes

P0138   O2 Sensor Circuit High Voltage (Bank 1 Sensor 2)
P0173   Fuel Trim Malfunction (Bank 2)
P0228   Throttle/Pedal Position Sensor/Switch 'C' Circuit High Input
P0281   Cylinder 7 Contribution/Balance
P0566   Cruise Control Off Signal
P0745   Pressure Control Solenoid 'A'
P0810   Clutch Position Control Error
P0853   Drive Switch Input Circuit
P0950   Auto Shift Manual Control Circuit
P0965   Pressure Control Solenoid "B" Control Circuit Range/Performance




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.