P0848 OBD Engine Code Logo   Code #P0848 -
Transmission Fluid Pressure Sensor/Switch 'B' Circuit High

Select a Code:


Honda Odyssey
I have 06 Odyssey. D on driving gear started blinking. Had diagnostic done today and it's teh P0848 sensor which is a transmission fluid pressure switch B-Circuit High. Suggestions on how to replace/fix? Mo


Van drives fine. Have yet to fix but I want to asap.

sudenly stops shifting and when i let it cools off for 15 minutes starts shifhing again

Suzuki SX4
P0848


Honda
car not moving as it is suppose to


P0137

GMC Sierra 2500HD
allison transmission


Scratch noise

Subaru Impreza
code p0082


Honda Odyssey
#P0848


P0848

just had sevice engine come whate can problem be

p0848 error code

pressure control celinoid b replaced it same code comes up not shifting up and shifts hard

2008 Suzuki sx4 told it was speed sensor on back of transmission

Honda Pilot / Transmission shifts properly the only concern is the D starts flashing at random / but it will still shift and operate properly.

P0848



Report your Experience!

Tell us about Code #P0848

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0154 engine light came on about 3 miles down road at 65 mph after replacing bank 2 sensor 1

P0882 My 01 pt cruiser sometimes goes into limp mode more often now. It has a 0700 code. I was told to replace the tcm but I am afraid if I do there is actually another problem. When I crank the car if the RPMs are high the car will be in limp mode automatically if no shifts and runs fine, it is all determined when you start the car if it will shift correctly and will be the same until the car is turned off and restarted.

P0660 driving shut off try to start its just clicking

P0513 Key

P0897 After changing the transmission oil and the filters, turn the ignition key to on position, transmission in neutral, shift to drive position, then neutral, back to drive, back to neutral, shift to reverse position and then back to neutral position. this should reset the code.



Other Check Engine Light Codes

P0130   O2 Sensor Circuit (Bank 1 Sensor 1)
P0169   Incorrect Fuel Composition
P0249   Turbo/Super Charger Wastegate Solenoid 'B' Low
P0313   Misfire Detected with Low Fuel
P0574   Cruise Control System - Vehicle Speed Too High
P0621   Generator Lamp 'L' Terminal Control Circuit
P0721   Output Speed Sensor Circuit Range/Performance
P0817   Starter Disable Circuit
P0984   Shift Solenoid "E" Control Circuit Range/Performance
P0992   Transmission Fluid Pressure Sensor/Switch "F" Circuit




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.