P0385 OBD Engine Code Logo   Code #P0385 -
Crankshaft Position Sensor 'B' Circuit

Select a Code:


Mercedes-Benz Sprinter 2500
PO404


P0909 ford won't select N

i have this code p0385 and p0155 i replaced cranshaft sensor and icm pip sensor and truck still have same codes

Ford F-150
can some one help


engen light come on about a year ago truck start fine and don't vibrates it doesen.t run smood buth is ok it just doesen't pass smog

Engine had no power in gear. Drove in low range around block. Truck died and wont start. Now the code reader shows the crank position DTC

po385 code on 96 F150 changed crank shaft sensor engine still bucks and misses hard when warm.

Ford F-150
truck runs great after clearing codes po 385 pps up !


Ford F-150
It does'nt passed the smog




Report your Experience!

Tell us about Code #P0385

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0304 Vauxall astra po304 put a coil pack on still miss firing on no 4 cylinder

P0783 no shift from 3 to 4 gear

P0141 Replaced throttle control assembly.Car runs

P0340 Nissan Maxima
every now and then the moter cranks but does't start, I can remove the key in and out then it well start the check engine light does't always come on but gives a 0340 code when checked


P0340 won't start but it does crank but doesn't turn over. after removjing the key in and out several times it starts and runs fine



Other Check Engine Light Codes

P0052   HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0120   Throttle/Pedal Position Sensor/Switch A Circuit
P0178   Fuel Composition Sensor Circuit Low Input
P0323   Ignition/Distributor Engine Speed Input Circuit Intermittent
P0354   Ignition Coil 'D' Primary/Secondary Circuit
P0615   Starter Relay Circuit
P0661   Intake Manifold Tuning Valve Control Circuit Low (Bank 1)
P0810   Clutch Position Control Error
P0886   TCM Power Relay Control Circuit Low
P0972   Shift Solenoid "A" Control Circuit Range/Performance




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.