P0335 OBD Engine Code Logo   Code #P0335 -
Crankshaft Position Sensor A Circuit

Select a Code:


GMC 2500
P00335


I have some fault codes: P0380, P1429,P1442, P1435, and rpm blocking 5000. thanks

Citroen
citroen c5 2.2 hdi


Alfa Romeo
P 0335 rpm sensor


hardcranckingbatterygoesdownwhenridingbike

2005 chevy equinox will not start. p0727

deleted the fault code and engine started

po337 knock senser

Hyundai Elantra
Does star


P0606

Citroen
p1664


Sea Doo RXT
Pro 335


Other Other
optra 2006 code check engine


Jaguar X-Type
Engine would not start until after 5 try's of 5+ seconds. Dud not see check engine light until this happened.


Hyundai Sonata
yesterday yes the car run ok no it dose not vibrate no it idle ok


The car its starting but not raving but if I clear the trouble codes it revs but when u switch of the engine it wont start till I clear the codes

Citroen
p0480


p0335

Nissan Sentra
p0335 code


ckp sensor change but not star engine

Ford Fiesta
P0335


p0335

p0335

Car: renault kangoo d65, f8q engine, lucas dcu3r ecu, epic iii pump. Sympoms: Engine has instabil ralanti, accelerates to about 1400rpm, then stop w P0335 error code. mil is off, injector warning light goes on when engine stop, then goes off. Cure: still looking for.

Accelerating and engine stumbeled, check engine light and ETS light came on.

Pontiac Grand Am
crank shaft sensor is less than 1 year old..


photo sensor code p0335

kia optima 2001 v 4 lx code p0335



Report your Experience!

Tell us about Code #P0335

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0775 need help in locating b valve solenoid or do i need the tcm that goes with that tranny

P0775 Nissan Maxima
i just put in a used tranny it does not go forward or reverse got engine code p0775 no b solenoid presure my trip tronic gear stuck on five please help


P0863 Ford F-250 Super Duty
engines check light code PO863


P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again



Other Check Engine Light Codes

P0064   HO2S Heater Control Circuit High (Bank 2 Sensor 3)
P0202   Injector Circuit - Cylinder 2
P0212   Injector Circuit - Cylinder 12
P0296   Cylinder 12 Contribution/Balance
P0313   Misfire Detected with Low Fuel
P0407   Exhaust Gas Recirculation Sensor 'B' Circuit Low
P0439   Catalyst Heater Control Circuit (Bank 2)
P0455   Evaporative Emission Control System Leak Detected (gross leak)
P0752   Shift Solenoid 'A' Stuck On
P0946   Hydraulic Pump Relay C ircuit Range/Performance




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.