P0305 OBD Engine Code Logo   Code #P0305 -
Cylinder 5 Misfire Detected

Select a Code:


Land Rover Range Rover
how to fix cylinder 5 misfire detected on range rover. I pulled code p0305 & p1170


NUMBER FIVE CYLINDER MIS FIRING

p0305 code changed inlet manifold gasket and i assume water was leaking into the inlet port causing a misfire,rechecked code and it hasnt shown up again , however this has disappeared when engine is hot,will wait until cold and retry and see if misfire reappears.

Rover Rover 45
changed inet manifold gasket due to misfire on number 4 when cold, only a small amount of water used and not overheating , will wait until tomorrow and see if the misfire returns when cold .


check engine light solid. comes on while starting car but then doesnt go out. p0305. replace plugs, wires and coil. 2004 chev suburban. 160,000mi. litte loss of power while accelerating up hills.

Ford F-150
misses


Ford F-150
misfire


the car shakes a litli

ENGINE RUNS ROUGH

Toyota Tacoma
V6 3.4 LITERS


Toyota Tacoma
ENGINE LIGHT ON START VIBRATE AND SHAKE IDLE ROUGH AND REDUCED POWER


Ford Mustang
f


hesitates at stop signs only

Volvo XC70
no check engine light, starts fine, but hesitates at idle


Ford Windstar
a weekago


Buick Century
When driving. Yes. No.No. No. No


Mercedes-Benz 500
car wont start po305 code


Ford F-350 Super Duty
Where cylindre #5


I don't know where the cylindre #5



Report your Experience!

Tell us about Code #P0305

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0863 Ford F-250 Super Duty
engines check light code PO863


P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again

P0139 Kia Spectra
replaced few parts for code po139 and check engine light pops up same cde po139


P0024 p0024&p0021 & p0300



Other Check Engine Light Codes

P0140   O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 2)
P0159   O2 Sensor Circuit Slow Response (Bank 2 Sensor 2)
P0199   Engine Oil Temperature Sensor Intermittent
P0203   Injector Circuit - Cylinder 3
P0330   Knock Sensor 2 Circuit (Bank 2)
P0349   Camshaft Position Sensor 'A' Circuit Intermittent (Bank 2)
P0451   Evaporative Emission Control System Pressure Sensor Range/Performance
P0552   Power Steering Pressure Sensor Circuit Low Input
P0794   Intermediate Shaft Speed Sensor Circuit Intermittent
P0803   1-4 Upshift (Skip Shift) Solenoid Control Circuit




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.