P0137 OBD Engine Code Logo   Code #P0137 -
O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2)

Select a Code:


Fiat
P 0380


07 pt cruser 12000 miles ana i have code p0137

Chrysler PT Cruiser
i have pt cruiser 12000 miles and i have code p0137 run good is using lot gas


p0711 peugeot 206

Pontiac Montana SV6
location of sensor


zd30 motor

Isuzu Rodeo
P0463


Chevrolet 1500
light is on


Pontiac Wave
2005 Wave CEL on , no drivability issues


Dodge Ram Pickup 1500
P0137 Oxygen Sensor Circuit Low Voltage (Bank 1 Sensor 2)


P0137 Oxygen Sensor Circuit Low Voltage (Bank 1 Sensor 2)

no symptoms yet told it may be 02 sensor

installed after market catalytic and bosch sensors

Pontiac Montana
car runs well still shows 137 after installing new cat and 02 sensors bank 1 sensor 2


Land Rover LR3
B152


Chevrolet 2500
Truck is a 4WD, V8 7.4L 454 CID Gas. I had a tune up done and there was a computer error code P0137. Tech said it was an Bank 1 Sensor 2 Oxygen sensor failure but the "Check Engine" light has never come on. The truck is a 1997 and has only 113,00 miles on it. Should I replace that sensor, and if so, where is it located? Before the tune up the truck was running and idling very rough and would shake. Gas mileage was really bad.


light on no noticeable changes

po137 code

Chevrolet 3500
starts hard


engine stalls on a stoplight

Chevrolet Chevy II
rough engine sometimes


Chevrolet Chevy II
high fuel comsuption




Report your Experience!

Tell us about Code #P0137

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again

P0139 Kia Spectra
replaced few parts for code po139 and check engine light pops up same cde po139


P0024 p0024&p0021 & p0300

P0811 excessive clutch slippage



Other Check Engine Light Codes

P0177   Fuel Composition Sensor Circuit Range/Performance
P0288   Cylinder 10
P0327   Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor)
P0524   Engine Oil Pressure Too Low
P0742   Torque Converter Clutch Circuit Stuck On
P0753   Shift Solenoid 'A' Electrical
P0822   Gear Lever Y Position Circuit
P0866   TCM Communication Circuit High
P0881   TCM Power Input Signal Range/Performance
P0993   Transmission Fluid Pressure Sensor/Switch "F" Circuit Range/Performance




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.