P0107 OBD Engine Code Logo   Code #P0107 -
Manifold Absolute Pressure/Barometric Pressure Circuit Low Input

Select a Code:


missing

The P0107 indicates that the MAP (Manifold Absolute Sensor) voltage is too low (< 0.25 volts) and generally indicates that the MAP sensor is either bad, a problem in the circuit or a problem in the Powertrain Control Module (PCM).

Nothing yet

p0380

no did not try to fix yet. but it state low input on bank #1

P0380 Board reay thermostarter or preheat. ECU,SC to + Batt.V.

p0107

Car stalling cutting out

whats this code

Po107

Pontiac Grand Am
replaced map sensor


p0107 it seems to be missing a little and a roug hstart

Peugeot 304
,jb/.


Peugeot 304
307 1.6


Peugeot 304
307


Peugeot 304
o[jji


Peugeot 304
FG;H;KIH


Peugeot 304
MN;;BJB;F


Chevrolet Optra
After a hot humid summer week, a severe thunderstorm caused engine hesitation and hard shifts from 1st to 2nd gear. Check engine light came on. After 2 days of dry weather, the car seemed to re-learn how to shift smoothly and the check engine light went off. The code in memory was P0107.


p107 code

Kia Sorento
po107


Dodge Caravan
Shake


nothing

Buick Roadmaster
the car runs great


po107 trouble intermittent optra 2005 2 litres engine

p0705

P0107

Had gas pedal to the floor and car wouldn't go. Then all of a sudden it took off. Check engine light on again. Codes found by Advance Auto: p0107, p0131-02 Sensor, p1166-No DTC and p1137-No DTC. Not sure where to take care to get looked at.

po107



Report your Experience!

Tell us about Code #P0107

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0775 need help in locating b valve solenoid or do i need the tcm that goes with that tranny

P0775 Nissan Maxima
i just put in a used tranny it does not go forward or reverse got engine code p0775 no b solenoid presure my trip tronic gear stuck on five please help


P0863 Ford F-250 Super Duty
engines check light code PO863


P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again



Other Check Engine Light Codes

P0058   HO2S Heater Control Circuit High (Bank 2 Sensor 2)
P0118   Engine Coolant Temperature Circuit High Input
P0372   Timing Reference High Resolution Signal 'A' Too Few Pulses
P0415   Secondary Air Injection System Switching Valve 'B' Circuit
P0601   Internal Control Module Memory Check Sum Error
P0727   Engine Speed Input Circuit No Signal
P0814   Transmission Range Display Circuit
P0854   Drive Switch Input C ircuit Low
P0957   Auto Shift Manual Mode Circuit Low
P0967   Pressure Control Solenoid "B" Control Circuit High




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.